Any system running The Eagle and/or the GTC should meet the following basic requirements:
The Eagle System Requirements
Administrator rights are required to install this software on Windows NT, 2000 & XP
IBM PC or compatible with 233 MHz Pentium or faster
256 MB RAM minimum
200 MB free disk space
VGA or higher monitor (800x600 or higher resolution)
Windows 98, ME, NT 4.0 (SP5 or higher1), 2000, XP
Microsoft Internet Explorer v5.01 or higher2
CD-ROM drive
Microsoft mouse or compatible pointing device
Modem connected to analog line (if not communicating via Internet)
TCP/IP Network protocol with Static IP Addressing3
LAN connection to Internet4
One free serial (COM) port if using electronic scale
One free serial (COM) or parallel (LPT) port for thermal label printer
Functioning modem driver5 (see Checking the Modem Driver)
The Eagle GTC System Requirements
Administrator rights are required to install this software on Windows NT, 2000 & XP
IBM PC or compatible with 233 MHz Pentium or faster
256 MB RAM minimum
60 MB free disk space
VGA or higher monitor (800x600 or higher resolution)
Windows 98, ME, NT 4.0 (SP5 or higher1), 2000, XP
Microsoft Internet Explorer v5.01 or higher2
CD-ROM drive
Microsoft mouse or compatible pointing device
Modem connected to analog line (if not communicating via Internet)
TCP/IP Network protocol with Static IP Addressing3
LAN connection to Internet4
1 Service Pack 5 for NT 4.0 is available on The Eagle Installation CD in:\Redist\WinNT4\SP5.
2 Available on The Eagle CD.
3 Applies only if using the FedEx Internet module. “Static IP Addressing” means that the computer’s IP address does not change. If you are unsure about this setting, please ask your Network Administrator for assistance.
4 Applies only if using the FedEx Internet module.
5 Applies only if you are using a dial-up UPS connection.